ทีโอเอ รูฟซีล ซันบล็อก TOA ROOFSEAL Sun Block

• 100% Waterproofing without joint
  
• 5 Times higher flexibility
  
• 95% heat flection with Ceramic Coating Technology
  
• Preventing & Fixing concrete from cracks caused by temperature change
  
• Sunlight & Severe weather resistance
  
• Film is highly scratch-resistant
  
• Safe for users, free from toxic chemicals

  ราคาขึ้นอยู่กับเฉดสีแต่ละเฉด โปรดเลือกเฉดที่ต้องการ ได้ที่ กด " ดูเพิ่ม " จะพบแคตตาล๊อก ติดต่อสอบถามราคา  083-2393626  ,  083-2396466  หรือ  LINE : @topaints   

• The surface must be clean from dust, cement laitance and oil grease.
• In case of mold and algae, brush and clean with TOA 113 Microkill leave it dry before coating with TOA Roofseal Sun Block.
• Deformed paint or coating must be thoroughly cleaned before application.
• Fill all cracks wide with TOA Polyurethane Sealant then leave it dry before coating with TOA Roofseal Sun Block.
• Repair concrete crumbling or big cracks on surfaces with TOA 112 Super Bond prior to coating.
• Polish the rust on metal surfaces prior to coating.

• Stir well before use, especially tinted.
• If the Roof slab, Mix TOA Roofseal Sun Block with clean water in the ratio of 3:1 and apply as the primary coat, leave it to dry for 2 – 4 hours approximately.
• If the Metal sheet, Apply TOA Rust Tech for rust prevention and enhance bonding ability to the paint and allow to dry.
• If the roof tile is old, apply TOA Contact Primer to enhance bonding ability of the paint and allow to dry.
• If reinforcement is needed, use TOA Fiber mesh after the primary coat immediately and press against the surface.
• Spray TOA Roofseal Sun Block with airless spray machine two or three times leave to dry for 2-4 hours in between.
• Toa Roofseal Sun Block will have the highest effectiveness 7 days after installation.

• The cracks must be sealed before the primary coat. Reinforce with TOA Fibermesh while wet before coating with TOA Roofseal Sun Block 2 – 3 coats.
• Toa Roofseal Sun Block should not be applied to new concrete less than 28 days old and other cementitious surfaces less than 7 days old.
• Do not use TOA Roofseal Sun Block while raining.
• For the polished surface recommend to use TOA Penetrating Sealer to enhance bonding ability to the paint.
• Toa Roofseal Sun Block uses for waterproofing for all horizontal ( roof deck ) or vertical masonry surfaces not suitable for long term water ponding (water tank). TOA Roofseal Sun Block gets full resistance properties after 7 days.
• Wash all tools immediately after use with water.

• Storage
  • - Keep all containers well closed.
  • - Keep in a dry cool place.
• Shelf life
  • 12 months in original packing.

  *** ถ้ามีจำนวนขอราคาพิเศษ ติดต่อเราได้เลย ***